Kam XY Laser RBP Instruction Manual download pdf (Page 2)

Thank you for purchasing this Kam product, we are sure that it will serve you for many years to come.

To optimise the performance of this product, please read these operating instructions carefully to familiarise yourself with the

basic operations of this unit. Please retain them for future reference.This unit has been tested at the factory before being shipped

to you.

To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture. To prevent a fire hazard, do not

expose the unit to any naked flame sources. Unplug this apparatus during lightning storms or if it is unlikely to be used for long

periods of time.

When installing the unit, please ensure you leave enough space around the unit for ventilation. Slots and openings in the unit are

provided for ventilation to ensure reliable operation of the product and to protect it from overheating. To prevent fire hazard, the

openings should never be blocked or covered.

If the unit is powered by the mains, always handle the power cable by the plug. Never pull out the plug by pulling on the cable.

Never touch the power cable when your hands are wet as this could cause an electric shock. Do not tie a knot in the cable. The

power cable should be placed such that it is not likely to be stepped on. A damaged power cable can cause a fire or give you an

electrical shock. Check the power cord periodicaly, if you ever find that it is damaged, replace it before using the unit again.

Contact your retailer for a replacement.

The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area

where this unit is to be used meets the required written on the unit.

The lightning flash symbol inside a triangle is to alert the user to the presence high voltage within the unit’s enclosure

that may be of sufficient power to constitute a risk of electrical shock to persons.

Caution: to prevent the risk of electric shock, do not attempt to open the unit. No user-serviceable parts inside. Refer all

servicing to qualified service personnel.

The exclamation mark inside a triangle is intended to alert the user to the presence of important operating and

maintenance instructions in the literature accompanying the appliance.

Select the installation location of your unit carefully. Avoid placing it in direct sunlight or locations subject to vibration and

excessive dust. Do not use the unit where there are extremes in temperature (below 41ºF / 5ºC or exceeding 95ºF / 35ºC).

Unpacking and safety Please unpack your new product carefully. Your new product should reach you in perfect condition.

Please check that no damage has occurred during transit. If any damage is found, do not operate your unit. Please contact the

retailer you purchased it from immediately. If there is any damage to the mains cable do not use the device. Always disconnect

the unit from the mains supply when carrying out any cleaning of the unit.

Manufacturer declarations

In compliance with the following requirements: RoHS Directive (2002/95/EU) and WEEE Directive (2002/96/EU).

If this product is ever no longer functional please take it to a recycling plant for environmentally friendly disposal.

CE declaration of conformity

R&TTE Directive (1999/5/EU), EMC Directive (2004/108/EU), Low Voltage Directive (2006/95/EU).

The declarations are available on application from certification@lambaplc.com

Before putting the devices into operation, please observe the respective country-specific regulations.

This manual contains important laser system safety and operation information. Read and understand all instructions prior to

powering on the laser unit the first time to avoid eye injury and to avoid breaking the law. Keep this manual in a safe place for

future reference. Lasers can be hazardous and have unique safety considerations. Permanent eye injury and blindness is

possible if lasers are used incorrectly. Pay close attention to each safety REMARK and WARNING statement in this manual.

1 2 3 4 5 6 7 ... 12 13

No comments

Kam XY Laser RBP Instruction Manual Page 2