Kam XY Laser RBP Instruction Manual download pdf (Page 9)

Connecting laser with DMX

Master slave mode (use without an external DMX controller

Choose 1 unit to be the master unit . using the menu button select the desired mode eg. Auto or sound activated

Connect a 3 pin XLR cable from the DMX output of the master unit to the DMX input of the slave unit (continue this to connect all

units in the chain)

using the menu button Select all other units to slave mode SLA press enter to confirm

Now all lasers will copy the master unit exactly

Note you Kam XY laser has 6 different slave modes SLA –SLA5 choosing a different slave mode will add a 2 second delay to the

slave units giving a far more versatile laser show

Example

1. set the first unit to as master, and to the mode required auto / sound

2. set 2

SLAVE unit to SLA 1

3. set the 3

SLAVE unit to SLA 2

This will give slave (2) a 2 second delay before it mimics the movement from the master unit, and then SLA (3)will react 2

seconds after the SLA (2) unit giving a staggered lighting display effect

Connecting a DMX controller

Each XY laser uses 10 DMX channels each DMX channel controls a function on the unit

When connecting a DMX controller, connect a 3pin XLR lead from the DMX output of your controller to the DMX input of the laser

unit

To control the laser with a DMX controller the unit will need to have a DMX address assigned to it

Press the menu button until the DMX address value is displayed 001 – 512

Press the up/down buttons until 001 is displayed

Press the enter button to confirm your selection

Note if the DMX address display is flashing this means that a DMX signal is NOT being received by the unit

If the display is not flashing a DMX signal is present

If more than one XY laser is to be controlled at the same time, there are 2 ways to do this

1. if all XY lasers are to be controlled the same, set all units with the same DMX address example 001

2. if individual control of each XY laser is required then each unit will need its own DMX address, example set unit 1 to 001

set unit 2 to 011 set unit 3 to 21 and so on adding 10 DMX channels to each unit

3. make sure that all units are at least 10 channels apart and that no channels cross over

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Kam XY Laser RBP Instruction Manual Page 9